Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Morning!I'm sure this question has been asked. But, I did some searching and couldn't find the answer I'm looking for. A high level view of our topology at our datacenter/NOC level is as follows:Firewall |Content Filter |Layer 3 core r...
Good Morning,I'm attempting to onboard a Cisco 9200 switch for visibility onto our Meraki cloud. I'm at the pre-check and getting all the way to where it wants IP routing turned on. Problem is this switch is an access switch and only needing to do la...
Good Afternoon! We have two ISE servers, just upgraded from 2.4 to 3.0 about a month ago. Yesterday I went through the process of registering the ISE licensing with out smart account using the token. Inside Cisco license manager I can see it formed a...
Hey All! We have a Cisco 3560X switch running iOS version 15.2. IP services activated on it. When I go into Conf t and run "IP multicast-routing I get a command not found. I can run IP multicast-routing distributed. Is there a difference in these two...
Hey All, We have a Go Daddy cert that is expiring. My question is if I need to generate a new CSR or not? I went to Go Daddy and got the same cert we are using renewed for two more years. When I download from Go Daddy I get two .crt files. One being ...
2.) Yes, we do need internet for this branch, appreciate that clarification. So, I'd need routes to the internet, DNS, DHCP and cameras.3.) Dang on the firmware! Guess we are going to need to look at new appliances if we want to go this route as well...
Appreciate your response!Correct, essentially we will just be providing this branch an internet connection. Also, access to the DHCP server and DNS and camera server. We have internal fiber from our NOC to the distribution switches. This branch doesn...
I understand that. I'm asking what do others do in this situation if the switch is only needed to do layer 2. Do they add a static route to just get their layer 3 switch? Do they just enable it and not do any routing? Or does Meraki only intend for s...
Thank you both for the reply. As this switch requires no routing, I just have it point via "IP Default-Gateway" to our layer 3 switch at that location for any inter VLAN routing or to get out the internet. I'd like to get this into the dashboard to b...
