Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I'm facing with a big problem. I need to optimize the configuration of a L3 core switch for one of our customer.
The starting situation: Global Routing Table, VRFA and VRFB. The protocl running on the core switch is OSPF. VRFA and VRFB curr...
Hi all,
I need to upgrade to ROMMON of SUP 8E from version 15.1(r1)SG5 to 15.1(1r)SG8 on a VSS Quad - Sup enviroment (4507R+E).
I found several procedures that explain how to upgrade ROMMON with Active/Standby Supervisor.
What is in your opinio...
Hi all, I have two subnets (192.168.42.96/27 and 192.168.42.128/25) assigned to the same VLAN.Is it possibile configuring a DHCP pool on a Cisco switch that can distribute IPs from more than one subnet? Many thanks,Maurizio
Hi all,I'm new with Meraki Dashboard and I would like to know if it possible to associate an existing SSID with a new Network that I have created.Many thanks,Maurizio
Hi all,
I implemented a new Cisco VSS composed by two 4507R+E in quad-supervisor architecture. After the migration from the old core switch to the new, the CPU usage of the VSS raised to 100%. Below the output of the show processes cpu sorted detail...
Hi Julio,
currently the communications between the VRF's and the GRT run at L3 with four Port-Channel.
Example:
interface Port-channel36 description *** GRT - VRFA , GRT side *** ip address 192.168.162.129 255.255.255.252 ip ospf cost 400!interfa...
Hi Leo,
thanks for your answer.
My IOS-XE version is 03.08.02 and the ROMMON version is 15.1(1r)SG5. I will upgrade the ROMMON to 15.1(1r)SG8. Is there some intermediate version or I can directly jump to 15.1.(1r)SG8.
To recap the sequence of ope...
Hi Mark, I think I will do so. Moving some of the clients or servers in ordero to obtain the segmentation that I want. So I will not need a dhcp pool with two subnets
Hi Mark, I have to implement VLANs segmentation on a LAN that actually is using a flat network (VLAN1 ). I have to move the DHCP server to the Cisco 3650 and I would like to avoid the reassignment of IP addresses. So I'm trying to subnetting the actu...
