Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How can the failure of the FirePower in an active Asa be monitored such that the Asa will failover to the standby Asa with the remaining functional FirePower module. Otherwise the traffic will continue to pass through the active Asa with the failed F...
Is there a way to set up an alert which will send an email for the following events: Administrator stopped/started the agent service. I have looked at the nt event log but only see when the agent service is started. Also, is there any documentation r...
I had a working vpn to a pix firewall, then set up cef per destination on the border router when second frame-relay circuit was added, now I am prompted for a password but the firewall hangs in the sercuring communcation channel phase. Here is the ou...
I have a 3005 in parallel with pix 515. Both inside interfaces connect to internal switch. From remote, attempt to establish vpn client connection to 3005. The attempt times out, event log sometimes shows that unencrypted packets were received. I not...
Marvin,
if using the on-box gui to manage the FTD rather than an external management center can you configure parameters such as site-to-site vpn?
Thanks in advance,
Christian
Rodrigo,thanks for the response. I saw the page you referenced but didn't see anything specific regarding the CX throughput. I believe there is reference to the ips module. I know the Asa can handle the 650 mbps, I just don't believe that the CX can ...
