Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If you experience issues connecting to a Cisco Catalyst 9200CX-12P-2X2G switch and don't see a USB port number for your console connection, follow the steps below. Symptom of the problem: You can't select a COM port (Putty, MobaXterm, SecureCRT) for ...
This is a procedure for factory reset if you need to proceed with it. 1- Device# factory-reset all --> Wait until you see the "switch:" prompt. After this step, there is no IOS on the switch at this moment. Only ROMMON. (NOTE: nothing will remain on ...
If you don't see counters on the Cisco ISE dashboard and receive the message "Unable to load Context Visibility page. Exception: Elasticsearch exception [type=search_phase_execution_exception, reason=all shards failed]," you can follow the procedure ...
This is a procedure for factory reset if you need to proceed with it. 1- Device# factory-reset all --> Wait until you see the "switch:" prompt. After this step, there is no IOS on the switch at this moment. Only ROMMON. (NOTE: nothing will remain on ...
