Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I'm trying to document a process to factory-reset a 9200L switch in order to prepare it production after being tested on in non-production. This would include also loading the initial factory image from flash. Does anyone have the steps and comma...
Hi,Configuration:2 x Cisco Catalyst 9200Ls with 4 x SFP+ uplink slots,The 2 switches are cross-connected over last port (24) with a trunk for all VLAN between switches2 x 10 Gb optical transceivers in SFP+ ports of each switch, connected to 2 data po...
Thank you so much! I added the "switch(config)#: no system ignore startupconfig switch all" to reable the startup-config.As for the mode button, I've read different things on different switches and have tried the "3 x mode button" thing at the right ...
Hi Leo. Just so I understand what you are saying, if I don't unset this variable "set SWITCH_IGNORE_STARTUP_CFG=1" and set it to "0", the switch will always be in password-recovery mode, even after doing a "write erase", setting a new enable secret a...
Thanks for all the help. Based on a number of pointers and this article, I wrote the following steps for anyone that needs to reset the 9200L without requiring to delete and replace the image once the switch is reset. In our case, the enable secret w...
Thank you. My concern is that what I read about the command, it will also delete all images from the switch too including the one that was installed when we bought the switch. It mentions in the documentation the need to tftp a new image back to the ...
Hi Paul. I noticed you mentioned to press the grey button initially until you bypass the boot loader. Considering 9200s have a different from other models in terms of resetting to factory, will pressing and holding this button work on the 9200s?
