I have UCS C240s w/ Cisco VIC1227 MLOM 10G cards. Can I connect these directly to my Nexus 9Ks, or do I have to run them through the fabric interconnects?
I'm looking for guidance, or documentation, regarding the threshold settings for unknown data plane packets, and packet-in message rate limits. I need verification that unknown data plane packets are punted to the SDN controller.
Thanks!
I need a way to verify, or the default behavior from Cisco, to determine the threshold filters or timeout periods for dropping excessive half-open TCP connections? Any info on this would be very helpful.
I would like to enable FIPS mode for the APIC's. I've found where to do it in the GUI. The reference guide states: "Delete all SSH Server RSA1 key-pairs." Where can I find these in the GUI, and how do I delete them?
I've also read that FIPS mode ca...
Is there any way to set the SSH timeouts for the APIC, LEAF, and SPINE devices? I can't seem to find the commands in the GUI or the CLI...
Also, the default logon attempt max is set to 5 is there any way to configure max logon attempts to 3?
GUI timeouts are managed there, and I have already set them. I am looking to configure SSH timeouts and logon attempts.
Also, there is no setting under security management for login attempts (at least not that I can see).
Thanks.
I set the web interface timeout settings as well, but they don't seem to be working either. What config parameters do I need to set for HTTPS timeout?
And yes, I agree, ssh login attempts need to be able to be configured. We need them at 3 failed for...