Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're looking at putting a 3640 into into a network that will have about 2000 private IP'd workstations. There will be about 10 - 15 NAT overloaded IP's, and the 2000 private IP's will be broken down into ACL's to utilize these. Besides the NAT'd I...
I have a 2611 running 12.1(19). I have cust. on the LAN side trying to VPN out to other places on the internet. They all have public IP's. Some of them are not able to VPN through our network, but if they dialup they can. Is there something I nee...
Does this look like a good generic T1 Multilink Config?interface Multilink1 ip address 192.168.10.10 255.255.255.0 no cdp enable ppp multilink multilink-group 1! interface Serial0/0 description T1 circuit ID etc.. bandwidth 1536 no i...
I've 2 t1's going to a 2610 from the same ISP. They are PPP encap T1's, no special routing protocol. I want to be able to use these 2 t1's as though it was 1 3mb pipe. How would I go about doing that?
I have 3 cisco routers...r1, r2 and r3. r3 connects to r2 and r2 to r1. All three are visible on the net. I need to be able to see r1 from r3, but I can't. r1 and r2 can ping devices all over the net, including r3. For some reason r3 cannot see ...
Does this look like a good basic config for multilink ppp? I'm using ver. 12.0(9)interface Multilink1 ip address 192.168.10.10 255.255.255.0 no cdp enable ppp multilink multilink-group 1! interface Serial0/0 description T1 circuit I...
