Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am running VMS 2.2 with CSA 4.0.3 clients, about 50 of them...I "purged" all the events from the MC to "clean" the database so to speak and now the agents are not reporting anything to the MC...Has anyone run into this or would know a way to get ...
Primary question: With the following statement from the Cisco Docs "T1 CAS fgd is asymmetric. When calling the switch, we only generate DNIS. When receiving from the CO, we get both ANI and DNIS", is there any way a T1 CAS can be set up to send C...
We have 2, 8 port Unity UM Servers. These are going to be paced in a 1 site, centralized CCM topology. We have deployed roughly 10 single Unity systems, and we have 2 Unity Engineers on staff. Can anyone describe the caveats with this deployment? ...
I have a 6 switch network (cat 6000's), with the following vlans: 1, 10, 20, 30, 40.I want to create two "domains" say Outside and Internal and I want to put 2 switch's in Outside and 2 in Internal.I also want only vlan's 1, 10, and 20 to be physica...
Is there a way to have music on hold scale to remote sites utilizing the centralized model. I understand that the music is sent via the G.711 codec unicast, what if I enabled multicast, will that basically be like sending a constant 80 kbps mu...
I am running into the same problem, I have IPSEC/UDP on port 9999, when the user opens Outlook, it fails, also, on the session table within the concentrator, the traffic TX - TX does not increment. Would going to IPSEC/TCP tunnl work over UDP?
I am trying to remove any single points of failure:I have another SRST senario, what if the WAN router, say 10.1.1.1 isn't the SRS router, and the SRS router is another router on the network, say 10.1.1.2. Then if I remove the ICMP redirect capabili...
Thanks for the reply, we are running 3.1What if I made the default gateway for the SRS IP phones the actual SRS router, say 10.1.1.1 (which is also connected to the WAN, and then made the default gateway for all other IP phones to 10.1.1.2, ( another...
The following Cisco Press book actually explains the pre dialing method and it also explains partitions and calling search spaces very well. The book:Cisco CallManager Fundamentals: A Cisco AVVID Solutionby John Alexander, Chris Pearce, Anne Smith, ...
