Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a cisco 3745 router that is showing high processor memory utilization. Here is the error from the output analysis of the cisco interpreter.ERROR: Processor memory utilization is 96.5787%. This is considered to be veryhigh.The system has ...
Hi,I have a cisco 3745 router that has 64 meg flash and 128 meg DRAM. I have "c3745-adventerprisek9-mz.123-14.T5.bin" flash image on. When I add a network module NM-HD-2V to the router I get scrolling "low on memory" errors and the router will not ...
does anyone know if there is such a cable to connect a pc's USB port to a router/switch console port? I know there are USB to serial adapters but wasn't sure if there was the direct cable to a telco console port
Hi, does anyone know if this part numberMEM3725-32U64CF is the same item as this:MEM3745-32U64CF.I am trying to put a upgrade our flash from 32M to 64M in our 3745 router and was told we could use the MEM3725-32U64CF . But when I tried, after the d...
Hi, I tried to upgrade our flash on our 3745 from 32M to 64M to accomidate a new flash image. The image I tried to put on was Platform: 3745 Feature Sets: ADVANCED ENTERPRISE SERVICES Release: 12.3.14T5 It copied ok via xmodem and then rebooted like ...
I also got this from the output interpreter. Do you know what could cause the memory to be so high?SHOW MEMORY NOTIFICATIONS (if any) ERROR: Processor memory utilization is 96.64849%. This is considered to be veryhigh.Processor memory or main memo...
the router is automatically adjusting it to 14%. I tried 20% and it gave me an warning saying it might be too much so I left it alone. I noticed the auto allocating didn't change from 14% when I put in the module although it saw it in its table. S...
