Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to upgrade Nexus 93180YC-EX to EPLD 9.3.7. In impact testing it shows that IO FPGA will be upgraded, however, after upgrade when i check this it wouldn't show as upgraded.(Following output is from 2nd try)SWH01# install epld bootflash...
Hi, We have 2 pairs of ASA firewalls at work. Main firewall we use to out for general and internet traffic, I have configured static one to one NAT configured and this is used for both direction. However on the 2nd pair of firewall, I am going to ad...
Hi Everyone,
We have a client's IPsec VPN running on ASA5520, now clients wishes to add another VPN. I have tried to add the 2nd VPN but its not establishing the connection. Client is using Sonicwall on their end for 2nd connection. I have used the s...
Hi Everyone,
This is my first post, I am new in networking. I have 2 questions.
We have Cisco 6509 Chassis with Supervisor Blade WS-SUP720. We are getting new 10Gig connection (It will be 1gig until we will upgrade our supervisor blade) from our IS...
Sorry I couldn't reply earlier as I was away...However, thanks for putting me towards right direction, I am sure I have understood correctly as below: nat (outside,inside) after-auto source static any any destination static obj_outside_ip obj_inside_...
Dynamic nat has been defined in the section 3, actually all Manual nat is in section 3 at the moment (same as i posted above) nat (outside,inside) after-auto source static any any destination static obj_outside_ip obj_inside_ip unidirectional no-prox...
Thanks for your reply Sheraz.I will try to explain the network below: 192.168.0.0/16 inside ----<ASA>172.16.1.1/29 (outside)-----------172.16.0.0/21(remote cloud network) I have been trying to workout if there is any particular need of this nat con...
Thanks Dinesh and Marius.
It was mismatch on the Sonicwall side. Client was adamant that he has configured everything right on his side. When I remote into them, it was set to aggressive mode.Changed to Main mode and got the connection straightaway.
...
Hi Leo,
Thanks for your reply. Really appreciate it.
Discussed it with my manager and conclusion is that for now we will be using Ethernet. But we are going to purchase new supervisor card "VS-S720-10G-3C". I can see some compatibility issues here.
...