Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is my situation:Outside VPN IP: 210.140.50.80-85 (using ficticious addresses as to not reveal my addresses))Inside VPN IP: 192.168.190.253Outside Trusted network router: 192.168.190.254Inside trusted network: 192.1.1.XIGR using 210.140.50.80PIX ...
My EnviromentW2K Servers W/ ADSCisco 1751 (IGR)Cisco PIX 515E (Firewall/VPN) 6.1I am relativly new to setting up proper VPNs and so far my experience has been with setting up VPNs off of W2K servers (w/ minimal security). I need some insight on how t...
I am rather new to setting up VPN connections especially on Cisco equipment. I need to setup about 10 users to be able to VPN into our network and use the HP Mainframe (telnet) and W2K ADS Network (file server, and possibly email). The only authentic...
Is it possible to setup AAA with MS IAS RADIUS SERVER I want to setup our PIX 515E-DMZ-R so that internal users need to provide a username and password to access the internet. In conjunction I would like to limit where people can go based on thier us...
A very general question:I am setting up a Cisco 1751 for internet access via a T1 line. It will connect into the outside port on a 515E PIX (DMZ/FIREWALL/VPN). Behind the 515E I will have our trusted LAN with an exhcange server for email.Where should...
I changed all the IP addresses these are all fake but it is the same topologyHopefully this explains it a bit better:(INTERNET) || \/ (IGR) --> 206.140.80.80 || \/ (PIX 515E) --> [OUT INT]206.140.80.81 [IN INT]192.168.190.253 ...
I just did it so I can tell you first hand:If you upgrade the PDM to 2.0 it will not interrupt service.However, to run PDM V2.0 you need to upgrade your PIX image to 6.2. Just copy the new image into flash. Then when you can afford downtime reboot th...
