Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all I have a FlexVPN setup with 2x WAN routers in a branch (let's call them R1 and R2) connected to 2x hubs (HUB1 and HUB2) R1 and R2 have a single ISP line each Hub 1 Loopback = 1.1.1.1Hub 2 Loopback = 1.1.1.2R1 Loopback = 2.1.1.1R2 Loopback = 2....
We have a number of ASA5506 running FTD 6.2.3 managed with FMCOne of the devices is not sending heartbeats to the management even after a rebootI logged in to the device over SSH and found that "show managers" command doesn't show anything:> show man...
Hi all I have 2x 5508 in SSO mode I performed a failover test (by executing command "redundancy force-switchover" and after the standby controller rebooted, HA seems to no longer be working:From active controller (Cisco Controller) >show redundancy s...
Hi allI've been having a major problem with Object Groups in FMC access policiesIf I have a pre-existing line in a policy with an Object Group which contains a list of IPs, if I add an additional IP to that object group, then deploy, the traffic is s...
HiI want to upgrade our FMC to 6.7 to upgrade our DC FTDs to 6.7 leverage the new IPSEC VTI functionality which was sorely missing,However, i've found that FTD 6.2.3 is no longer supported to be managed by FMC 6.7. We have 30+ devices which are on 6....
I managed to hack my way around this using flexconfig, for example: dhcprel enable inside Replace "inside" with the name of your VLAN interface (you can't put "dhcprelay" because it's not a supported command....) Raised a ticket with my reseller, hop...
Did you solve this?I've hit the same problem on my FMC (6.6.3) with FPR1010 (FTD 6.6.1)Can't configure a DHCP relay for VLAN interface... absolutely useless product...
TAC didn't give me any other options than to reimage the device. Was a real pain to get someone on site to connect a console but eventually managed that and did the reimage. Reimage solved the problem but it really makes me worried some more may fail...
WLCs are in 2 different halls of a datacentre so the VLAN is on a switch Problem was VLAN not allowed on the trunk between the WLCs! Issue solved and HA is working fine now, no problem with the WLCs
