Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I'm currently having BGP running with 2 ISPs on 2 routers at 2 data centers as a failover setup with AS Prepending applied on a /24 advertisement on the router at the second data center. I have a 1Mb connection going to this data center throug...
Hello,I'm in the process of setting up BGP between 2 ISPs at 2 data centers. From ISP A to data center A, I have 4 T1 lines configured with "ip load-sharing per-packet", from ISP B to data center B I have 1 T1, and I have a /24 assigned to me from IS...
Hello,I'm in the process of setting up BGP with 2 connections coming in from 2 different ISPs on two routers at 2 different locations. For interconnect the 2 locations, I have a point to point T1 line going, my question is if I use this T1 line to se...
Hi all, I'm trying to config the LocalDirector for loadbalacing a website, the problem that I'm having right now is http requests from internal network to the virtual server which resides on the DMZ of my Pix firewall. I know that I can access any ...
Hi all, My company is gettting a bundle of T1s from the same ISP to create a big pipe of 6mb since we can't get a T3 here. The thing is this IPS doesn't support Multilink PPP and CEF... I was told that I need to use Source/Destination routing to cr...
AS appending isn't enough, you have to check with both ISPs to see their list of community settings to see what you should use to make one primary and one as backup.
Hello all,It looks like AT&T sets up static routes to the /24 I'm advertising instead of using BGP. Did a "show ip bgp regexp MyAS#" on AT&T's route server, it showed all routes through AT&T and nothing from the 1st ISPThank you for all your help.Bes...
Sundar,Is it possible to use ip addresses from the IP space I'm advertising to assign to router's interfaces while it's still being advertised?In regards to my last post, I have 4 T1 lines from ISPA and 1 T1 line from ISPB, I'm thinking about using ...
Sundar and Martin,Thank you for your answers. So from Martin's reply, the loopback interface on both routers can have the ip address from the ip block that routers are advertising, and so updates are being sent throught loopback interface instead of ...
I'm not sure if you can set up the 7200 as a hardware client in network extension mode (may need to look at cisco documentation on setting up a cisco router as a hardware client and setting up the cisco 3000 concentrator to allow network extension mo...
