Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a client which access a server through Exceed application which uses UDP port 177 and gets a reply from the server on UDP port 6000.How do i configure this through PIX firewall.The Client is on inside interface and the Server on DMZ.RegardsPat...
Hi, I have the following command configured on an Async line.line 129 no motd-banner no exec-banner exec-timeout 0 0 flush-at-activation modem InOut autocommand telnet <ip address> <port>/noecho transport preferred telnet transport input all stopbi...
I have a 3662 with an 8AM card istalled and AAA configured for remote user to dial in,i have configured a single line which will allow dial in, but i dont need any authentication on this line, but when i dial it prompts for a username and password.pl...
I have the following message dispalyed when i type show isdn status.Global ISDN Switchtype = basic-net3ISDN BRI0 interface dsl 0, interface ISDN Switchtype = basic-net3 Layer 1 Status: ACTIVE Layer 2 Status: TEI = 23, Ces =...
