Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi experts, My customer gave me another challenge, to replace all cisco NAD to H3C. Here is their request, do the posture check, if the PC is no compliant, put them to VLAN 60, then put them to VLAN 20 after their PC compliant. Everything is OK ...
Hi Experts,
I just want to make a simple wired web auth in ISE, but after URL redirect, when I click next button, it poped this notice, this question make me very confused. I already built the new guest-portal, changed different id squenece, but i...
Hey guys, here's a question.
Last year, we depolyed 2 ASAs, and they are configured as failover mode.
Use these commands:
failover interface ip lan_failover 192.168.1.1 255.255.255.0 standby 192.168.1.2 failover interface ip stateful_failover 192...
Here's a question I've meeted, pls help me, thx a lot!
When I first setup my ISE 3595 in CLI mode.Then in the same subnet, I used my computer to ping the IP address which I configured, it's connected! But I can't open the admin web. Does anybody...
Already solved. The key is CISCO provide the HP Wired Device Profile is not include port bounce attribute. But the second authorization needs the port bounce to change vlan. So I searched forum and RFC 5176 about COA. Founded the solution about this ...
Thank you for your reply, I set it's sending successful message. And, I found resaon,LOL! It's cause by browser, when I changed to IE, it worked. And it hit right authorize policy!
Hi guys, meet same question, so did you resolve it, my customer is make me carzy that they do not allow change access 2950 sw, but we must do this NAC project, thank you very much!!!
