Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Does anyone know it you can use the thousandeyes EA on a C9300 where the VLAN connecting the agent is mapped directly to an SVI on the switch rather than via a L2 front panel port? version 17.3.4 is running on the switch.
It's a branch switch, w...
Hi EveryoneJust deploying PI 1.2 for a new wireless network, in a new building. Does anyone know if:1. You can import floor plans with structural information about the walls etc directly into Prime maps.2. How do you do it.3. What sort of diagrams do...
HiI am attempting to configure an ACE4710 to perform SSL end-to-end confguration. i.e. SSL termination - load balance - SSL initiate to backend serverThe configuration appears to work fine in a test lab using any old web server, however when I peform...
HiDoes anyone know how to change the directory that WCS uses for the scheduled backup. By default it uses the ftp location specified during install, but I need to change it to another disk partition and can't see how you change it. I can do so for ma...
Hican anyone tell me if this url match in the contend rule is valid.url "/*.tvlistings.blah.com/*"We are trying to match urls oftest.tvlistings.blah.comlive.tvlistings.blah.cometc.i.e. we need to match the tvlistings.blah.com in the URL
Hi I found the problem, as the switch is part of a stack and in this case the stack master is switch 2, i needed to configure app port 2/0/1 and not 1/0/1. Regards Dave
I had a similar problem when the workstations where set to 'computer or user authentication' within PEAP settings. What was happening is that the DACL that was used for when the computer account was authenticated restricted access to just the DCs etc...
HiThe answer to this one is that the http header was greater than 4K so needed to use a parameter map to increase the header size that the ace would look at.Thanks for the advice
Hi PabloHere is the sanitised config, neither the lab nor production environments use any nat. The SSL config is only required for the port 4443 vserver.RegardsDave=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2012.06.01 00:23:28 =~=~=~=~=~=~=~=~=~=~=~=h run [J...
