Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a customer with many nexus 4000 blade switches, all are running 4.1(2)E1(1h). The switches crashes and reboots by itself. "cdp hap reset" seems to be the problem. I can't find anything about this issiue on the bug toolkit.Has anyone else seen ...
Hi all!I have two ASA in failover with Active/standby configuration. When I switch from standby to active from the standby ASA I get a lot (like 100) of error messages like these below:asa5585/sec/stby# failover activetransport_gport: ERROR - UDP inv...
Yes the data rate will not exceed 54Mbps when WEP or TKIP encryption is configured as unicast key. radio policy of ssid will not show N as a radio policy you need to enable it globaly. is your client N capable? you do not need to upgrade to get N spe...
you need to go to wireless>802.11a/n>High Throughput (802.11n) and enable 11n mode. Also do this under radio 802.11b/g/n.Regards Bashirhow to enable 100mbps speed on cisco wlc 2504 with 3600 ap
Hi Anu, Thank you for the fast reply, the bug id seems to under review for publishing in Bug toolkit so I can’t read about the bug. It feels better now when I know that this seems to be a cosmetic issue, we are going to upgrade to 8.4 soon so that sh...
