Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Let say There is a 500 line ACL on a cisco router. And I have to make some changes in the ACL like addition of a new ACL entry somewhere between ACL entries. I copy all the ACL entries in a notepad and edit it. Now when I will do no access-list <a...
Hi Guys,I have some confusion in understanding below backup ISDN dialer list configs:dialer-list 1 protocol ip list 101!access-list 101 deny eigrp any anyaccess-list 101 permit ip any anyDialer-list 1 is calling the ACL 101 that is blocking EIGRP t...
Hi All,I have a query as follows:X NET (100.200.1.X) ------[(NAT outside int)-NAT Router-(NAT inside int)] ------- Y NET (192.168.1.X)Suppose I have configured NAT to translate 192.168.1.x network to 100.200.1.X.If I ping/trace from X NET on NATted I...
Thanks Reza. I got the reply from Cisco as well - "The VACL capture concept is unique to the 6500/7600 architecture hardware ASICs. For a 3750x, you have to use the monitor session/Local SPAN type configuration for packet mirroring."
Mohammad,I do not know about your complete topology but from the given information, R2 is your PE router and there is no network advertised in BGP address-family ipv4 vrf and there is no BGP address-family VPNv4 neigborship.You will find BGP VPNv4 ro...
Hi Guru,You can refer following link to understand the Policy Based Routing concepts in details.http://www.ciscopress.com/content/images/1587050722/samplechapter/1587050722content.pdfHope this helps you.Regards,Amolak
