Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem with a simple topology. WAN remote prefixes are learned through BGP from MPLS provider and through EIGRP over VTI through the Internet that acts as a back up for MPLS. The router normally chooses BGP routes for lower admin distance w...
We have a 6509 running Cisco IOS. If I move a module to a different slot the config remains at the old location even though the old slot is empty. Anyone know of a way to remove the config that is associated with the empty slot?
I need to filter routes by adding a tag to routes in EIGRP. I need to add a tag globally to all routes in one neighbor so that all updates from that neighbor are tagged. Any ideas?
I have a 6509 running native IOS and I can not figure out what the syntax is to span a port on it. Set based switches are no problem to span but we can't figure it out on this native IOS box, we have a sniffer set up and just need to know what the s...
Thanks, after a little study, I discovered that you can only apply tags in redistribution. I was wanting to apply tags to all routes from a neighbor router to be able to filter those routes from an EIGRP to OSPF redistribution a couple of hops away. ...
All you need to do is set up static routes that are dublicated for both T1s. I would point them to the IP address of the far-end interface rather than out the local interface. If a T1 drops and the far-end IP is unreachable, the router will not forw...
I agree with Mick, i't tough to get the Telcos to work the problem. You might try changing encapsulation on the serial interface on both ends. If its HDLC go to PPP or the other way around. Also we have experienced many issues with telco clocking.Dep...
