Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have encounterd a broplem on my Cisco 805 model.When i use the command "show ip interface brief" the status shows "up" but the protocol is "down" on my serial interface.The link between my to sites is down after this happend.This just happend ou...
Hi,My Cisco seems to be stuck when it boots up, with the following:Upgrade ROMMON initalizedAnd it goes on with self comperessing image then an OKbut then it starts loading again all over.Please help!!
Hi, I am relly new to Cisco and having a hard time with my Cisco 2800 series.I have two sites connected with each other SiteA and SiteB (Using the same Cisco 2800). Now site A can connect to site B on the cisco and the internal network, but site B ...
Hi,I have been doing some reading, could it be that the IOS is taking up too much space when decompressing?I am really struggeling with this one.Any help please?
Hi, I have tried to boot the Cisco witht the other flash but its not working its incompatible with the platform.Are there any other sugestions please?Would i be able to download directly from the internet to the cisco for a new ISO?Any help would be ...
System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 2009 by cisco Systems, Inc.Initializing memory for ECC.c2811 platform with 262144 Kbytes of main memoryMain memory is conf...
