Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I had my 1250 set up to use Radius auth and act as a dhcp server to it's wireless clients. I now have a wireless camera that I wanted to add to the mix but it does not support Radius (EAP) so I've got it configured for WPA2-PSK. When trying ...
In my update this morning, I removed the dhcp scope and just have one scope /24. I have tried to assign the device an IP that is in the dhcp excluded range. I don't see where to assign an IP to VLAN13. I'll have a look through the docs to see if I ca...
I've tried that but the camera does not register its ARPAP Web Gui - Show associationsDevice Type Name IP Address MAC Address State Parent VLAN unknown NONE 192.168.20.8 0014.d1f2.0992 Associated self 13ho-wifi1#ping 192.168.20.8Type escape sequen...
I've removed the ip helper for VLAN 13. Does this mean that the DHCP server on the AP cannot assign IP addresses to both VLANs? The problem is that the network for the wifi devices is small and I do not have any servers in there, just the AP. The oth...
The issue is that DHCP is notworking on VLAN 13. VLAN 1 is working fine.Also, when I set a static IP for the camera on VLAN 13, the ARP entry shows as incomplete.The AP plugs directly into a firewall port and does not pass through a switch.ho-wifi1#s...
