Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, In the production network, we are using firepower 9300 with ASA 9.8.2. during NAT translations we are getting " Duplicate TCP SYN from CGN_INTERNET: X.X.X.X/58487 to CGN_INTERNET: X.X.X.X/25268 with different initial sequence number". please ...
Hi all, In VM maestro after launching the simulation, we are getting an error " these images are required by topology but not available to STD: IOSXRv64" for IOSXR9000, IOSXRV64 images. we are running virl 1.5. Please help me to get on this IOS XR64b...
hi all, we have an issue with firepower 9300 security module 2.when we are seeing the hardware status it is showing unassociated. we referred the Cisco document it showing " Unassociated—Thesecuritymodule/engine doesn't have a logical-device associat...
Hi Abheesh, Thanks for your replywe tried that one also. After changing the security module slot 2 to 1. it is showing hardware status "compute mismatch". Thanks,sandeep
Hi abheesh,Thanks for your reply So you are planning to cluster all three SM modules right...??yes. I am not sure with ASA image you can intercluster the SM Modules. I have did with FTD image for one customer. we found the below doc link. ASA suppo...
Hi abheesh,Thanks for your reply.Yes I connected the logical device(ASA 9.8.2). Actually we are configuring clustering with all three security modules. Let me know if you need anything. Please suggest me Thanks
