Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a few access-lists with a total amount of 800 lines. The average CPU util is about 11%.It says on the datasheet that you can configure 128'000 access-lists. Is the total amount of lines?Does anybody have a performance analysis which e.g. state...
Hi. When I go through all conversations about directed-broadcast etc (see title), I'm a little bit confused. We use a Cat6000 MSFC2 with latest native IOS and following config:interface Vlan1 ip address 172.16.1.1 255.255.255.0 no ip redirects ip dir...
If I configure an IP address on the native vlan (e.g. vlan 1, bridge group 1 -> bvi 1) I have full connectivity towards our ethernet environment. If I create a new vlan with a new linked bvi and configure again an address, I cannot access the device ...
Hi. Is it possible to increase the adm distance of directly connected interfaces? It is possible to change the adm. dist. for routing protocols, but I've nowhere found a hint if it is possible to also do that for direc. con. int. Thanks for every rep...
I know that "outside nat" exists but have not seen any possibiltiy to do an outside nat based on the destination address. Is it possible?Example: client on outside network accesses a server in the internal network. If outside client tries to connect ...
Thanks for the hint. Do you maybe know how much performance impact it will have when you e.g. configure 2000, 3000, 10000, 50000 access-list entries? Do you know the maximum CPU util of a FWSM so that the FWSM does not drop packets?
Hi CraigThank you for your explanation, it helped a lot! Just one last question:As far as I understand, ip-helper is not only used in conjunction with udp forward. Per default, ip-helper also forwards bootp/dhcp requests to the specified addresses, c...
Info: we had "similar" problems, always with 1 group of switchports. RMA's for different modules on differents switches (all 65XX) did not solve the problem. The customer is now observing the temperature of the box as the event doesn't occurs regular...
