I'm just wondering why I cannot see the modem and hardware version if I'm running sh cellular 0/0/0 all . Is there something that I need to active before ? Or is there a issue with the hardware module ? R1#sh cellular 0/0/0 all
Hardware Informati...
same issue also on 1861 yourname#sh version
Cisco IOS Software, C1861 Software (C1861-ADVIPSERVICESK9-M), Version 15.0(1)M4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
...
sh version R1#sh ver
R1#sh version
Cisco IOS Software, 1841 Software (C1841-SPSERVICESK9-M), Version 15.1(4)M12a, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Tue ...
OK interface is set to "no nut" but get same issues no mobile and hardware version and get only message "%CELLWAN-2-SEND_TIMEOUT: Cellular0/0/0 not responding" R1#sh ip int brief
Jan 2 12:02:00.491: %SYS-5-CONFIG_I: Configured from console by conso...
