Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone knows what are the other connections means? As far as i know, i'm the only one logged in(2 vty 0).Does anyones knows about the other lines,host means (Se4/0/1:1, Se5/0/2:1 ?? Sync PPP)Doest this mean other users are logged in via these in...
Can we establish connection if one router is using DS3/E3 ATM Network Modules port and the other using a synchonous E3 WAN port.3600(E3ATMport)<->CSU/DSU<--WAN-->CSU/DSU<-- | ...
1. Is it possible to bridge an ethernet port to and E1 WAn port on a cisco router.2. How Can it be done.ethernetport<router1>WANport------leasedline------WANport<router2>EthernetWhat are the cisco router that supports this configuration and what ...
This maybe a little bit basic but shoot..If a user subscribing E1, 2Mbps leasedline, wouldn't there bea bottleneck at the part where v.35 interface going to his router from the ntu?since the V.35 interface was originally specified by CCITT as an int...
Can this be done... [Client]<---wlan-->[AP]<--eth-->[cisco1700]<---serial(leasedline)-->[3600(nas)] What i'm doin is to enable pppoe over wlan. Can cisco AP bridge the client to the nas. What are the requirements and settings for the AP/1700/3600 ?? ...
The purpuse i'm bridging is to pass vlan tags through the two links.Is there any other way beside bridging that i could do it over an E1 WAN link?The only other way that i could think of is to pull a direct fiber to connect the two LANs.Thanks for yo...
But i still want the client to be able to dial using a pppoe dialer using theirpc/laptops. I checked out cisco pppoe guide and it mentioned about bridging.Could i use the 1700 to do bridging over the serial line ? The examples show how cisco 1417/82...
