Hi firends ,I have setup following lab In my site12 I have configure OSPF in vEdge1 service VPN (VPN1) .Then 10.2.16.0/24 is advertised by vEdge1 and vEdge2 .vSmart select only the route which is advertised by the vEdge2 as it is redistribute to the...
Hi friends,can you please help me to understand the Tunnel concept use in the SDWAN.1.What is the tunnel source address ? (is it physical IP address bound with the tunnel)2.What is the tunnel IP address ? (is it the system IP)3.WAN-Edge device use s...
Hi Friends,Can you please explain where therse serial Number and chassis Number contained in the vEdege.Is it contain in the Avnet certificate ? Thank you very much for your support Manoj
Hi friends,Can any body expalin how Chassis number ,serial numnber ,TPM chip and Avnet certificate coming to the play in PnP/ZTP process.Thank you verymuch for your effort and time.
Thank you very much for the reply.Please help me to confirm following understandings.so ,in the point 4 , also the controller DTLS connection will use tunnel mode and in this case also New IP header IP address and original IP header IP address is equ...
@balaji.bandi and @Jaderson Pessoa Thank you very much for reply.My actual confusion is with the quote "•Designated Port is the Port in the designated bridge connected to the LAN segment with the least cost" and it is also illustrated in the diagram...
Update....Actually after I configure default route from both vEdge routers Full WAN connectivity obtained.But If I create static routes to obtain the same connectivity it is not working.....For a example :If create following summery routes insted of ...
Thank you very much for the reply.I just have one issue .As far as I Know, By default, WAN edge routers try to form overlay tunnels to every received TLOC from a different site using every available color (Like following diagram)As per my observation...