Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a rather basic question about portchannel and dual ISPs. I have a Active/Passive ISPs where ISP2 is only active when ISP1 fails.
On ASA side, I have 2 subinterfaces with different IP address and vlan (999 for ISP1 and 998 for ISP2) assigned ...
I have 2 floors and 3 ISPs in my company network, and I would like to implement ISP failover with static route. (diagram attached)
For Floor 2, ISP failover is set up with IP SLA tracking.
What I want to achieve is that, for Floor1, if ISP1 fails, ...
I'm using WLC 2504 8.3 So, I would like to implement something like guest wifi login page like starbucks, airport, or any other public wifi where it first displays terms and policies to connect to guest wifi and only allow guests to browse after acce...
I have 2 ISP links that I want to set up SLA Monitor through FMC.
I'm able to ping those two uplinks from my firewall. I setup SLA Monitor as shown in screenshot (attached)
2 ISP default routes screenshots are attached, as well.
However, as soon as ...
I'm having trouble adding FTD to FMC. Originally I was managing FTD locally with FDM, but lack of features got me moving to FMC.
I ssh'd to FTD, and issues the command configure manager add <FMC IP> <Reg Key> and now it says 'pending'
I went on to ...
sla monitor 10 type echo protocol ipIcmpEcho 1.1.1.2 interface outside num-packets 3sla monitor schedule 10 life forever start-time now
I only have static routes in my environment, so no advertising default route, unless I'm missing some knowledge ...
NVM fixed myself. Turned out that I should point to main outside interface from zone/interface list. Also, found out NAT policy can't use same source object.
Thanks for the reply. I was doing some extra research after reading your reply, and I think what I'm looking for is L2 WPA+WPA2 and L3 passthrough options. Now all I need is to figure out putting on a custom pageThanks!
