Greetings,
I am running Cisco Prime Provisioning 12.3
I created my domain and syncing it. After that I created service areas, User roles, and then service templates. All of these are properly associated to their applicable service areas. I go ...
This worked great for me. Thanks for following back up on this thread. I am using a windows 10 machine and exported from a unity 9.1.2 version. Thanks!
Another option that I have working on CUCM 11.5 is...
Support or 4digit direct transfer to voicemail (as described above using CTI route point) as a prerequisite
create a translation pattern as applicable for DN ranges ( i like to be specific)
...
It was all user error on my part
After you create your service templates... Navigate to User Provisioning > find your target user and click on the names then just select custom service wizard. NOT the first option. The provision services is just...
I ran into this same problem and ran gathered some RTMT logs and noticed that the phone was calling itself. So as a workaround i just put a forward all destination and the calls then went through to the intended destination
Behavior in: CUCM ver...
Thanks again for the reply. I opened a case and was informed that I was not using the tool correctly. In the user provisioning section I needed to select my user and then select the Custom Services Wizard. The provision services button on the user...