Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Just looking at AP configuration using 5508 WLC. We have APs deployed at all branch sites connected over a corporate L3 WAN to a Data Centre which houses the WLC(s)When setting the AP for Flexconnect mode there is a requirement that one nativ...
Hi All,Can anyone help with the followingI have a legacy PIX 501. I have created a static NAT as followsInside host (192.168.1.1) to NAT to outside address 10.1.1.1 (not the real ip addresses)So, I''ve configured staticstatic (inside,outside) 10.1.1....
Hi AllI'm after a bit of a sanity check here.I have a situation where I need to implement a VPN between a third party site (A) and one of oursite (B). On our site (B) will be a number of users from the third party organisation with dataand voIP requi...
Good Morning.Does anyone have any information of the above commands when applied to DSL controllers - particularly when applied to GSHDSL WICS? The documentation, to me at least, is a little unclear. I understand thay can provide improved line stabil...
Good afternoon (or morning depending where in the world you are).Can anyone help me with the following?We have a requirement to implement connectivity to a number of partner sites from a number of our satellite sites. Traffic will be varied but will ...
Thanks Scott. That's fair enough. Haven't had a great deal to do with wireless in the past and am reviewing a current configuration. Helpful answer - so thank you!
Thanks Scott. Is there an underlying reason for this feature? It seems to fly in the face of best practice for VLAN security (albeit the risk being small). I thought maybe I was misunderstanding something but if it's a requirement then I'll configure...
Thanks Scott. Is there an underlying reason for this feature? It seems to fly in the face of best practice for VLAN security (albeit the risk being small). I thought maybe I was misunderstanding something but if it's a requirement then I'll configur...
Hi,Here is the info you asked for - hopefully it is what you need...Thanks for your help so far!nameif ethernet0 outside security0nameif ethernet1 inside security100 object-group network VPN-CONC network-object object-group network VPN-ENDPOINTS ...
App is great!I'm not back into work for a couple of days but will send requested info then. Thanks for the reply.Sent from Cisco Technical Support iPhone App
