Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I ran into an interesting issue this evening. While upgrading our B200 blade from 2.0(1t) to 2.0(3c) our servers did not boot into the Cisco firmware utility. The system showdown the OS, rebooted and began the OS load, then during mid-...
Hello,I am using an HID Omnikey 5321 contactless card reader to authenticate to our Windows workstations. Everything works fine for users not required to pass through the Ironport, but my attempts to bypass the proxy for this authentication keeps fai...
I ran into this recently and both of them use the same encryption engine. DLP policies will trigger messages to be encrypted; however, policies are processed top to bottom and left to right, so DLP policies will be enforced after Content Filter polic...
This occured after applying the new firmware policy to the server/host. Our Maintenance policy is set to User ACK so after acknowledging the activity the server began the firmware upgrade. I saw the same behavior on an ESX host and a windows host so ...
I added both the FQDN and the network range to the proxy bypass, but still get the same results. I tried looking at the access logs, but they didn't return anything. If I use the policy trace it always allows the trace with a user name, but the omni...
