Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are replacing our Internet carrier and struggling to find the best method to migrate our IPs over with Zero downtime given the DNS replication lag around the world. We have 4.5 Mb connection from Windstream into a 2901 Router with 3 public range...
We are in the process of switching MPLS providers and I am looking for some advice on configuration at our head end. We need the head end router to run both MPLS networks at the same time and then we will switch our remote offices one at a time.Here...
Our Cisco rep pointed us towards the 2600 for its superior dynamic range and our need for decent low light performance. Our vendor pointed us towards the 4300 for better image quality and OK low light performance.Looking fro some real world experian...
Ok a little background on my setup. We have users that connect from outside to our ASA. There are 2 groups of users. The first group needs a valid cert the second does not. Everything was working fine up until 11/3. Our asa's identity certific...
I am trying to setup my 5506x running 9.6.1 and can't seem to figure out how to use the management-only routing table. My inside and management interfaces are on separate subnets. I can ping the management interface from it's subnet but can not rou...
Tarjeet,I am confused on how this would help me. For example we host websiteA.com, when we change the DNS for that site it would take 24 hours to replicate and I would need the website temporarily avalible on both IP's until the new DNS has complete...
Thanks for the info Harold. I had another thought. If I can use the same AS for both MPLS netowrks can I just add a neigheibor to my bgp?Example:router bgp 65000no synchronizationbgp log-neighbor-changesbgp redistribute-internalnetwork 10.0.0.0redi...
