Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a number of 350 AP's. When 40 bit WEP is set non-cisco wireless adapters can associate and function but when set to 128 bit these clients do not work. Is this a general restriction to using 128 BIT wep? Chris
Scenario is central site 2600 router with e1 pri interface and 6 remote sites with 801 BRI routers.Remote sites are configured for dial-in central site is configured to accept incomming calls. However when i configure the central site router to make ...
Hi I am trying to set up outbound dialing on a Cisco 2600 with E1 Controler. It already accepts inbound calls but when I change the config to attempt out bound calls the call setup fails with the following q931 output:ISDN Se1/0:15: TX -> SETUP pd =...
Hi,I have an issue with exactly how to configure an aggregated E1 and what modules will support this.The scenario is this.BT have provided a GBUK circuit which aggregates a number of Kilostream links from remote sites. The circuit is an E1 circuit wi...
The issue that was two fold. firstly outbound dialing was not working from the central site router - the ISDN switch on the service providers nework was sending a message back saying it was unabel to allocate a channel to make the outbound call. But ...
The central site config I included has a dialer map statement for one of the remote sites. I included thia as an example. I will try and get the debug out put over the next few days and post. Do you think this will help being as it's not the connecti...
I need to add add the static dialer map on the central site to allow it to bring up the connection and dial the remote site, i.e. 2 way ddr. The dynamic map is created on the central site when the remote site dials in but obviuosly if the central sit...
Thanks for your reply.I know the config for the 801 is not the router that is configured in the central site config I just used it as an example their are 6 of them. The debugs I have tried - as I said the routers connect and authenticate ppp fine it...
