Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It is stated that 8.0(150.3) is fixed but the latest version on https://software.cisco.com/download/release.html?mdfid=283791169&flowid=&softwareid=280926605&release=8.0.140.0&relind=AVAILABLE&rellifecycle=ED&reltype=latest ist 8.0.150.0?
Hi,I just updated to PI 3. Now, old (detected) templates are stored in "Templates / My Templates / Discovered Templates". There are about 500 templates resulting from "AP Authorization".New templates are stored in "Templates / … / Features and Techno...
Hello,I'm on PI 1.4 with 7.6.201.0 From time to time I get an audit mismatch showing that PI and controller values differ in "Rapid Update Mode".I understand that rapid update changes update time for CleanAir from 15 minutes to 30 seconds and that a...
Hello,I would like to ask some questions regarding steps 4, 5, 19, 21 from Release Notes for WLC Release 7.0.240.0.The (optional) step 4 recommends to disable the controller 802.11a/n and 802.11b/g/n networks and a note says: "For busy networks, cont...
Hello,I would like to ask if this is a known issue and if there is a remedy:When issuing a "sh local-host <ip-address>" I often get an increasing count of connections for this address, whereas a "sh conn local <ip-address>" and a snmp query with .1.3...
Hi Salma,Thank you very much for your explanation. Nevertheless, the configuration mismatch messages are disturbing.So, there are two questions left:a) Is there really no way to set the Rapid Update status manually?b) When the status will be reset to...
Hi,I would like to add another question:From Mike's answer I understand that the counter may differ if there is a heavy load on the NPs.What would be of interest is why the counter from sh local-conn doesn't come "back to reality" after a while and l...
Hi Mike,Thank you very much for your hint! Unfortunatetly, it's still not possible to query 'np block' per snmp and move load isn't really a solution.What's strange is that this symptom strengthens when there are static entries to limit connections. ...
