Hello!
I have the following Hunt Group configuration on CUCM 11.5:
1) Handset 1000 has a Call Forward No answer to Hunt Pilot 2000 with a Ring No Answer 5 Seconds
2) Hunt Pilot 2000 is configured as Broadcast with 1000, 1001, 1002 as members
3) W...
Hi All,I have an H.323 gateway configured between my CallManager cluster and an Alcatel 4400 PBX. There are no routers involved, I am just pointing to the IP address of the Alcatel and visa versa.Everything works OK apart from when I call an extensio...
Has anyone tried installing Cisco Video Advantage within a VM Ware session?The connection between the hardware phone and the Video Advantage application does not come up; as if “Video Capabilities†has not been enabled on the handset or the PC is...
Hi All,I have a CallManager 5.1.2.3000-2 installation where the Caller Display of the Calling Party is NOT displayed until the destination goes off hook - This is between two internal handsets connected to the same cluster.The user receiving the call...
For anyone with a similar issue, I managed to resolve this by increasing the Busy Trigger from 1 to 2. I'm not sure why this has fixed the issue as once the call is forwarded to the Hunt Group, the initial call is terminated! 10 points for anyone who...
I know it sounds a bit of a strange configuration, but the reason the caller is presented to the handset initially is so that they have the ability to set a call forward all. I know that 5 seconds is not long, but can this be preventing the hunt grou...
Hi,Did you you manage to resolve this issue?I have exactly the same issue and I am running the same version as you!What happened when the license expired?CheersColin
Hi Guys,Many thanks for your assistance, I now get a ringtone with the following configuration; 1) Media Termination Point Required2) Enable Outbound FastStart3) Codec For Outbound FastStart: G711Thanks also to Nick for pointing out the "Use ANN for ...
