Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I wonder if anyone have heard about device support for the ASR 920 in LMS 4.2.5?I have checked both the supported device list and the special notes document and they dont mention ASR 920 at all right now.BR Christian
Hello, is there any way of doing "Netshow" in Cisco Prime Infrastructure 2.1?For those that dont know:Netshow was a function in LMS where you could enter a ad-hoc command, ex. "sh ip ospf nei" and run that on multiple devices and then export the outp...
Hello, I have run into a problem with system jobs.I noticed that our automatic backup stopped working and the reason is that two system jobs is in the running state.When I try to stop them I get this output:---Error:Cannot stop job 1019.6718 because ...
Hello, we are running LMS 4.2.2 and our Topology maps have stopped working and I noticed that the ANIserver process is down.By tailing the /var/adm/CSCOpx/log/dmgtd.log i got the messages below, any idea whats going on?A shutdown of LMS + reboot did ...
Hello LMS community, I am a bit confused about how LMS 4.2 monitors interfaces that is shutdown and hope that you can share you experince with this problem.I have a router with a vlan interface configured with an IP but shutdown.Even though LMS detec...
Update:With the latest Autodev and MDF packages I now have all expect Fault Discovery working, opening a TAC case for that.Description Cisco IOS Software, ASR920 Software (PPC_LINUX_IOSD-UNIVERSALK9_NPE-M), Version 15.5(2)S, RELEASE SOFTWARE (fc3) T...
Hi and thanks for your reply, I have since the original post tried a stop / start and it removes the running job. But after a while it comes back, and Im not sure removing the job is a good idea, as it is labeled as "Maintenace job" and is scheduled ...
Hello, tried a stop / start but EssentialsDM stalled, tried another stop /start and then it woke up.So in fact a tripple restart and its working again Thank you again for fast replies!BR /Crille
Hello and thank you for a fast response from you both!Attached is a zip with these files:/opt/CSCOpx/campus/etc/cwsi/ANIServer.properties/opt/CSCOpx/campus/etc/cwsi/ANIServer.properties.orig/var/adm/CSCOpx/log/ani.logI could not find a aniserver.log,...
