Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Lucien.Why do you need the associate the the physical port to the port-channel out of the config-sync command.Is it not possible to do this in config sync, and why not.??ThanksAd
Hi,Copy "show version" and stack trace output in the cisco output interpreter.https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.plYou see than Possible bug matches.Regards
Leave the config as it is, but put ip nat outside on the interface FastEthernet 0/1.Traffic that hits acces-list 1 will be nated on loopback1.Return traffic goes directly to 20.20.20.1, without going to the loopback1.-
