If a core and access switch have different etherchannel load balance methods, will the mismatch cause errors or performance issues?e.g Core src-dst-ipAccess src-mac
I have the same problem.I'm thinking IP SLA or BGP rather than static routes so only one route is in the ASA's table at a time.Would love to enable asymmetric across two VTI's though
Hi DSI’m trying to put multicast MDT into production on 2 x 4507 core switches (+ 3 x 4500 access switches) interface Loopback0ip address 10.255.255.101 255.255.255.255ip pim sparse-mode ip pim bsr-candidate Loopback0 32 101ip pim rp-candidate Loop...
OK, so if I have 2 SVI's on a switch (SVI x and SVI y) with "ip pim passive" configured on each, I can have a source in SVI x and a receiver in SVI y and shouldn't have a problem. IGMP is needed, but not PIM for this to work. Correct?So I gave this ...
