Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attached is a rough Network diagram of what I want to achieve but cant find a way:A client over the internet connects to 216.1.2.2(internet IP on R2) but this gets automatically redirected to 216.3.3.6(internet IP of Server on Lan behind R1) so they ...
Attached is a rough Network diagram of what I want to achieve but cant find a way:A client over the internet connects to 216.1.2.2(internet IP on R2) but this gets automatically redirected to 216.3.3.6(internet IP of Server on Lan behind R1) so they ...
I have a small Lan(10.0.0.0) with a cisco gateway router as the gateway. My users are remote and they are required to use RDP to login to out systems and this is woriking fine.However I have a group of users that are located at a very far distance a...
Guys is it possible that a public IP can be automatically routed to another public ip.For example I have two routers A and B.router B has a LanB in 10.0.0.0 network and the public ips are in the x.x.x.0 for internet access.router A is located at a re...
I have set up VPN on a stick on my router and my VPN is established but I cant get to the internet after the client gets the VPN connection, my Nat translations are not taking place when i check using the show Nat commands.What I require is that use...
Hello toby,I am a bit confused about the Nat. By setting the tunnel 0 on R1 as Ip nat Inside does this mean the traffic will be automatically routed from R2?Wont we need any form of Nat on R2?I am a bit confurse here.
Hi tobyarnett I configured the tunnel but now I am confused on how my user traffic will use 216.4.4.2 to get it automatically routed to the Lan on R1 since they are all remote?.Here is the configuration I have come up with I created a Gre tunnel bu...
I am attaching a rough diagram of what I want to achieve.Lets say I am on the internet (Remote User) and I want to get the server on the Lan behind R1 whose regular external IP is 216.3.3.2 provided by ISPA, .I have set R1 up using regular Nat and...
Hi Collin,I have tried the regular Nat but doesnot seem to work. In my case a client uses one internet IP but automatically gets redirectd to another Internet IP behind which is the actual Lan :unlike regular Nat which is public to private.A client o...
Sorry have been busy and didnt look at this since.I was a bit confused from the configuration and diagram of R1 as the diagram has R1 with loopback 1.1.1.1 which I suppose represents the internet ip so in my case shouldn't 1.1.1.1 be the same as 12.0...
