Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Unified Communications Manager 9.1.2(1 Publisher - 7 Subscribers - 2 TFTP Servers) We have recently added some SIP softphone clients in our UCM and during our testing we found that in certain cases if you called a SIP softphone from an IPT phone - (S...
Hi,I have a IPT remote site connected via the WAN to a 2851 Router configured as the SRST gateway, so when the WAN link fails back to the main site where the main UCM Cluster resides, phones should be able to dial out via a local PSTN link.When we ca...
Hi Everyone,I have a strange problem here which I hope you can give me some guidance / help on.We have a Call Manager Cluster running 4.1.3 with Pub, 6 subs and 2 TFTP severs at the main site and 1 sub at the remote site. We have a number of gateways...
Hi,we are planning to upgrade our Customer's Call Manager from 4.1(3) to 6.1(2)and am fortunate enough to have a 'test' system.I have loaded and run the Data Migration Assistant 6.1(2) on the test system and it fail sValidation with 6 errors similar ...
My Customer is running Call Manager version 3.3(5) and has 4 1700 series routers each with 1 E1 circuit configured as H323 gateways. Last week when the carrier's circuit on the first choice gateway went down; (loss of layer 1); outgoing PSTN calls di...
I think the issue is that Cisco calculate that BST ends on 4th Sunday in October which was yesterday, but the power that be determined that BST ends next Sunday. We are running 9.1.2 and a 7942 is showing the correct time but others are not. If anyo...
Hi Brian, In the file – ‘287’ – I See the following which looks like the SIP client telling the calling party who to contact to complete the call before it drops:- 83725382.001 |15:00:47.320 |AppInfo |//SIP/SIPUdp/wait_UdpDataInd: Incoming SIP UDP m...
Hi Brian,I have remade test calls and put the final called party into the same CM-Group as the SIP softphone client, which I hope makes the tracing easier. I also had to use a different SIP softphone client, so here are the call details for the attac...
Hi Brian,thanks for your offer of help. In the attached files there is the failed call – the details of which are shown below:-Calling Party – (IPT SCCP Extension) 808226 10.221.115.98Called Party – (Wave Soft...
