Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several Tandberg/Cisco C40 codecs with TC 4.2.0 version software. These codecs will randomly reboot themselves. I have not noticed an fluctuation in power and they are all on UPS and power conditioners. I have found no discernible pattern to t...
I have the subject cameras hooked up to C40 codecs in all my conference rooms. This morning I discovered that one has gone myopic. It will not come into focus. I did not inherit any manuals for this equipment when I took this job so I'm kinda sh...
I have a Cisco/Tandberg C40 in one of my clients' conference rooms and today it would not show any of the menus or icons on the screen. I thought at first it was the remote, so changed batteries, then changed remotes, but I kept hearing the beeps as ...
When issuing the NO SWITCHPORT command on a 4500 the switch hangs. The only workaround at the mement is to shut the interface down before changing processing layer on the interface.
I have found an as yet unregistered. Does anyone run 4500's with Call Manager using MOH in Multicast operation? Do you experince high CPU, but show platform traffic stats shows only 1 - 5 % traffic loading?
Thank you both for your responses. I will be updating the software as soon as I can. Contract is pending before Cisco will release it to me. As for heat, I haven't noticed it being an issue. The cabinets are well ventilated and it's still too bloody ...
Ok, having finally been able to telnet into the codec this is what I came up with:xstatus camera 1*s Camera 1 Connected: True*s Camera 1 HardwareID: "0f000000"*s Camera 1 Manufacturer: "TANDBERG"*s Camera 1 Model: "PrecisionHD 720p"*s Camera 1 Softwa...
Hi Mubashshir,Thank you for the response. The model looks to be the 4x. I cannot find anywhere on the web interface that identifies the camera model or SW version. I do not know how to get to the xstatus or xcommands. The web interface does not ap...
I checked the system this morning and the monitors looked fine. To be sure I cross checked the settings against a similar system in another conference room. The H and V position settings were slightly off on the system not showing OSD so I set them t...
Thank you Amlesh, I will not be able to check the unit until tomorrow morning. In looking at it from teh web browser I do see that the OSD is set for option 1, HDMI. So it may be a change in the monitor done with the monitor's remote. In any case I w...
