Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Is the main request in this post to establish L3 connectivity?If so, as stated above, configure the switch to be in router mode. Configure IP addresses on the the three VLANs' interfaces. Ensure the VLANs are up (active trunk or host port). Ch...
Hi Mark,What is the switch ports', connecting to the bridge, configuration (trunk, allowing required VLANs)? I'm not familiar with EZ bridge. Do you reliably see any CDP messages or BPDU's from one switch to another (On one of the switches, mirror ...
Hi,On calls where there is no caller ID available, the label of the FXO port will be displayed. It can be edited to say Sales or Repair.An alternative could be to route the call to a shared line designated for the sales or repair teams.Hope that hel...
