Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If I wanted to disable websense filtering, but not completely remove my configuration, how would be the best way to do that? Could I shut down the websense server, can I just remove this line - "filter url http 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 allow"...
I am running a Cisco ASA 5550 in active/standby mode. We are currently running ASA OS v8.2(3)5. I am wondering if there is a way I could limit source IP concurrent connections coming in my outside interface. Does the ASA have a feature/ACL syntax ...
I am needing to setup communication between my local LAN segment and a remote LAN segment using private IP addresses. We currently have a VPN tunnel up between the two sites, and we currently NAT our private traffic to a public IP and send that over...
I'm trying to define the difference between an OSPF neighbor and an OSPF adjacency. I'm wanting to see how you guys would explain this. I'm under the impression that OSPF neighbors are routers that are in the same area and that is running OSPF. An ...
I am just wondering if there is a rule of thumb as to how many mirror ports you should put on a 3560G. Our email administrators have asked me to mirror 5 or 6 ports going to different servers and while we should have the processing power and bandwid...
krahmani323,In this documentBuidling an adjacency steps :http://www.cisco.com/en/US/tech/tk365/technologies_white_paper09186a0080094e9e.shtml#t22There's a key phrase in the adjacency section that tied it all together: "multi-access segment". By defi...
That makes sense. I'm playing here in packet tracer and I created the following topology:(Sorry for the bad drawings)I'm not getting a DR and BDR elected in this topology. Since I'm not getting a DR election, does that mean none of these routers ar...
