I have a quick question for the forum members. I am building a network with lots of guest traffic. I would like to have a captive portal layer 3 security with a customized website loaded on the 9800-40 for guest user Authentication. I am searching ...
Team I know the higher the number the Less the power. The Available transmit powers, have always been 8 of them 1 through 8 1 being the Highest and 8 the least power. As per the below is it safe to assume that the 9120 will not run less than 3.13 mW...
I have to solve an issue with redundancy and i was wondering which option would require me less gear for redundancy? would it be N+1 or 1+1 with SSO?
Would anyone have come across similar like issue?
Good morning to the gang in here, I have a small question, possibly may be redundant and I extend to the team the sincerest apologies.
I currently have an active, CCNA, Wireless CCNA and CCNP (about to expire in April 2018).
My question is the fo...
Dear forum members, has anyone come across a Cisco Validated Design for a municipal WIFI solution? If so I would sincerely appreciate if someone can shed some light on some research and reading I have been doing for sometime now.
A high level archi...
Leo I am trying to do the exact same thing you indicate below on a Cisco 2504 Controller. When I do so I get a pop up message stating that "Key Hash is needed for location servers with SSC"
Leo I am trying to do the exact same thing you indicate below on a Cisco 2504 Controller. When I do so I get a pop up message stating that "Key Hash is needed for location servers with SSC"
Leo good day to you and thanks for the reply, this is not a duplicate thread, the one you are referring me to is my thread as well and it has to do with me asking how to solve high channel utilization. In this thread I am asking that since I shut do...