Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
i'm trying to setup a ether-channel on WLC Controller 5008.
Till now, the Channel was not showing as connected (even after reboot).
Any idea about the issue?
Neighbor Switch:
Gi1/21 po3-wlan-ctrl notconnect 1 full 1000 10...
Hi Community,
i have some problems to use my cisco c2811 router. After accidentley deleting the flash:/.bin file, my IOS is not available anymore. For that reason, after restart, the router is in a continous loop with boot: cannot fload "flash"
Is t...
Hi all,i tried to update one of my stack switches to a newer version.Unfortunately, there seems to be an issue with the newer IOS version (or at least it is not synchronized) through all switches. I already tried to copy the bin files from the stack ...
hi all,there is a certificate issue with my wlc (AIR-CT5508-K9 - Cisco 5500 Series Wireless LAN Controller - Software Version 7.3.112.0). when i logon to my controller there is an issue:There is a problem with the security certificate on this website...
hello all,i'm trying to grant access to a shared folder in seperated vlan. but it does not work. no connection possible. any idea?systems are both win7 (without any firewall restriction etc.)vlan 1 (normal office vlan) to vlan 2 (seperated vlan)inter...
Hi Ric,
the issue was very stupid one. Even though i changed both cable directions, there was an issue with the cable catch at the end of the cable. There was a minimal gap to the SFP input, so everything was configured properly, but the port channe...
Hi Ric,
yes first port will be replaced through the last 4 ports with OM3 LC
Havent tested yet with GLC-T transceivers as i dont have one on short notice...but yes i could test that as well.
Outputs:
lan-core-#show interfaces gigabitEthernet 1/23Gi...
Hi Ric,
WLC was rebooted after LAG enabled.
I use 1000 BaseSX SFP with 50/125 fiber cable , i assume that it is not only working with GLC-T with UTP or am i wrong?
Hi Ric,
config port adminmode all enable -> done
(Cisco Controller) >show port summary
STP Admin Physical Physical Link LinkPr Type Stat Mode Mode Status Status Trap POE SFPType-- ------- ---- ------- --...
Hi Leo,
i was not aware, that it is "so" easy to just copy the IOS file to the CF card.
This worked directly (more effort to find a card reader )
Thanks for your help! Appreciated!
