Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 asa5505. I want to create ipsec tunnel. Do as write this http://www.cisco.com/en/US/docs/security/asa/asa72/getting_started/asa5500/quick/guide/sitvpn_b.html#wp1038592But tunnel does not establishciscoasa(config)# show crypto isakmp saThere ...
Using SDM (V2.34) i create GRE tunnel between cisco routers (2811 and 2801). Tunnel is up, and Test connection (SDM tool) write that tunnel is ok. Ping of sites on other side is ok. But any application (netbios, rdp, www) not work. Please, say, where...
In secondary office we have 2 low speed connection to ISP (ADSL modem with Ethernet). Each interfaces have own ip address. I want simultaneously use this interfaces to increase total bandwith of internet connection.I think i can do:interface Loopback...
At first - excuse me for my EnglishI have 1760-V router with CME 4.05 - 7912 ip phone (Skinny)2 - SIP ip phone from D-Linkone FXS card with two FXS portI write dial-peer for Sip phone#dial-peer voice 1010 voip#destination-pattern 1010#session protoc...
Today to connect to service provider i use PC with WinXP, and connect through Windows VPN Client VPN type - PPTP VPNauthorization - MS-CHAP-V2encryption - not presentI want to change this computer on Cisco router 1841 (Cisco IOS Software, 1841 Softw...
