Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
While changing a voicemail box password in Unity, I get the following message:
Access to the requested resource has been denied.
The attempted action was a violation of security protocols and will not be allowed. Please try another action....
Hello,
We're setting up an extension that needs direct inward dial, but it doesn't seem to be working. Is this enabled in the call manager or is it something that needs to be set up with our phone company?
Thanks.
Hello,
We inherited a phone system that was out of compliance - as in the former regime went over on licenses for the Call Mangaer and didn't use the compliance period to correct the problem. We have been able to get a temporary license in order to ...
Hello,
Our core switch routes all traffic to our Cisco ASA 5520. We have point of sale stations that are being set up for credit card transactions. In order to complete that setup, our workstations need to be able to communicate with two addresse...
Hello,Our core switch routes all traffic to our Cisco ASA 5520. We have point of sale stations that are being set up for credit card transactions. In order to complete that setup, our workstations need to be able to communicate with two addresses: ...
Hello
The new output is below. 10.30.144.146 is the address I am pinging from. I do not have NAT set up for the destination addresses.
asa# debug icmp tracedebug icmp trace enabled at level 1accasa# ICMP echo request from inside:10.30.144.146 to...
Hello,These are the results from the first commands:accasa# capture asp type asp-dropaccasa# show capture asp0 packet captured0 packet shownaccasa#These are the results from the packet-tracer commands:packet-tracer input inside tcp 10.30.144.6 22 63....
The POS stations have MAC address reservations on our DHCP server. I ran the debug command and the ping from the ASA. Please let me know if that isn't correct. The POS is 10.30.144.146. Below is the output:
ICMP echo reply from 10.30.144.146 to...
Ok, I enabled it on the ASA, and it now shows as a hop in my tracert output. Beyond that, it times out. I think this reinforces that traffic is being dropped at the ASA. Would you be able to offer any insight on the proper permit statement(s)?
T...
