Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm currently setting up a multiple SSID wireless network in my office, I wanted to keep one SSID as Guest-mode, and one for internal user. each will connect to different VLAN.The problem is, whenever i have both SSID setup inside the AP, all i could...
As my title described, just wanted to make sure if this is possible or not. I did try to put up a config like this, but the router is not negoticate any tunnel at all.any reply would be appreciate thanks
I have a PIX515e with OS 6.3.3, and i used to created all these LANtoLAN tunnel with my third vendor, but now i don't need these connection anymore. I delete all the config that relate with the tunnel, but I still keep getting MM_Key_Exchange from fa...
Hi just wonder how can i stop icmp from outside at my PIX outside interface, i try to put acl on my access-group outside, but i can still ping from outside, am i missing something?access-list acl_out deny icmp any anyaccess-group acl_out in interface...
Hi I have this weird problem, I'm using cisco VPN client 4.03 and PIX515 running on 6.33 code. I have no problem creating a vpn tunnel to the pix, but all i could do is PING, no TCP packet returning. here is my config access-list split permit ip 172....
Darren, I have a similar situation which i was using a Cisco VPN client to create a tunnel through a PIX515E. I'm not sure about the Nortel VPN client, but for Cisco's VPN client you could pick either TCP/UDP to setup a tunnel, I could use both proto...
Hi, Just wanted to make sure, is you client behind PAT or static NAT? does the Checkpoint on the other side support NAT-T? what FP is the checkpoint using, you might want to check that.I would try to give this PC a static NAT translation, and create ...
Thanks for your reply, actually i already have ACL apply on the outside interface, let set permit icmp any any. But problem still happen to be that way, always require inside host to initial traffic, then outside can access. I understand this is not ...
Hi I'm experinecing a similar situation, with vpn client and the borderware. Since the borderware is my third vendor's firewall, i have no control to it. Have you find a solution to this? if so, i would really appreciate if you could give me a hint. ...
