Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone ever come across this? I input the commands for spanning tree. It looks like they are accepted just fine, but when I check the running config, they do not show up.r401-dis-sw4#sh ver Cisco IOS Software, C2960S Software (C2960S-UNIV...
I have a 3945 with a basic DHCP configuration applied to it. This 3945 is connected into one of the access ports of my nexus switch. I'd like to simply have the 3945 hand ip addresses out to other clients connected to the nexus switch. I have zero ex...
I have been given limited information as to what the specifics are on the telco circuit that is installed here. I'm unable to get any calls to go out the PRI here. Any help is appreciated.card type t1 0 0controller T1 0/0/0 cablelength long 0db pri-g...
I have 2 seperate satellite connections running @ 2mbps. I am looking to load balance my internal network over each of the two connections. So far, I have been unable to get both connections to be used simultaneously. Network layout is as follows:Sat...
Got this solved a little while after posting. I forgot to mark it closed. Customer said the circuit was ready to go. Not quite the case.. The B channels were still locked. Lesson learned.
ccapi output:CME1#csim start 900718002882020Time out, no test result is received from DSP!Dec 7 15:19:06 HKT: %RADIUS-4-RADIUS_DEAD: RADIUS server 17.209.119.12:1812,1813 is not responding.Dec 7 15:19:06 HKT: %RADIUS-4-RADIUS_ALIVE: RADIUS server 1...
