Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello together,we try to log hits to ACL entries to a syslog server.We have an access list which blocks HSRP packets. We seen them in 'show logg ip access-list cache'show logging ip access-list cacheSource IP Destination IP S-Port D-Port ...
Hi all,I'm looking for informations about MDI/MDI-X on the Ethernetmodules for the Cat6500 with Sup720 and IOS.For the Cat6500 with CatOS I can find this information in the release notes of the software.But there is nothing for IOS at least nothing I...
Hi all,I have tried to configure CBWFQ and PPP Multilink on an ISDN BRI interfacewith DDR. The dialer load-threshold is set to 1 so that both b-channels of the BRI interface are connected when the link comes up.I need a traffic class with a minmum of...
Hi,this is not complettly right in my eyes.With Nexus1010 version 4.0(4) you are not able to change to role or domain ID without a reinstall of the software. And there for you need the .iso image which is not available on CCO for anyone.So you need t...
Hi Robert,thanks for your answer.So, it is little strange.We had configured ACL logging again from scratch and use an other syslog server and now it seems to be working.We see all entries in the syslog that we see in the acl log cache.I don't really ...
Hi Robert,thanks for the great discription.Is there a difference between "normal" data plane traffic and traffic for the control plane for the logging point of view?We have an access list which blocks HSRP packets. We seen them in 'show logg ip acces...
Hi Subash,in my eyes you can not do this with only the loopback.You can try the following:interface Gigabit 0/2 bridge-group 1!interface gigabit 0/1 bridge-group 1!interface BVI 1 ip address 10.10.10.1 255.255.255.0!bridge irbbridge 1 protocol ieee b...
Hi Subash,for me it is not clear what you want to achieve with this config.In my eyes you could configure the two LAN interfaces with bridging and the Layer 3 interface would then be a BVI (bridged virtual interface).Then you have a direct Layer 2 co...
