Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have attached a diagram with this discussion. First please have a look at it.The thing is; I had seen on design recently. There was more than 20 sub interfaces with IP address assigned in a router which was connected toa switch. The port was obviou...
Hi Mentors,I have a dual connection from two service providers ( provider A & Provider B).In my internal network, I have two Vlans (vlan10 & vlan 20).My requirement is users belonging to vlan10 should go via ISP A and for vlan 20, it should go via I...
Hi Mentors,I have currently a Cisco 3600 router, it has three interfaces (all ethernet interfaces only).We being a client, our requirement is, we want two links one being the primary and one secondary for the failover.My ISP has done certain configur...
I am really having problem with the implementation of HSRP over intervlan routing.I configured the HSRP for multiple Vlans (10 &20), but both of the routers are in Active stage. I couldn't figure out where theprobem lies. I have two routers (Cisco AS...
Thank you for your response.yes! the vlan associated with the physical interface has been configured as native vlan. So, I'm confused here why we made the physical interface a part of native vlan.Please clarify me.My question may seem like a query fr...
Hey Calin, Thank you very much for the reply as i had not got any it since I posted the particular disscussion.The IOS that I am using in my Cisco AS5300 is c5300-ik9s-mz.123-22.bin. I went to the feature nagivator from the cisco.com website and its ...
Thanks a ton man...You are a life saver..Muaah.!!!I finally resolved the issue..yes, I finally found out the until and unless we create the vlans in the switch,it cant tagg the vlan traffice for the intervlan routing.Cheers,Thanks Again.
I have two routers which are connected to the switch. Cisco 2950 is just there for the intervlan routing.Doesnt it support the intervlan routing??I have configured the HSRP on two Cisco AS5300 Routers.Darren, I am not clear with your logic, would you...
The configuration is as follows:interface Ethernet0/0 description wlink_fiber ip address 202.166.217.248 255.255.255.0 no ip proxy-arp no ip mroute-cache half-duplex no cdp enable ! interface Serial0/0 no ip address shutdown no fair-queue ! ...
